No I don'the have a 3d printing obsession

Discussion in 'Show off' started by Miasmictruth, Feb 16, 2017.

  1. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
  2. Tom De Bie

    Tom De Bie Well-Known Member

    Joined:
    May 7, 2016
    Messages:
    191
    Likes Received:
    33
    How do those tables stand up to the vibrations while printing?
    Fire extinguisher...smart idea btw ;)
     
  3. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    Lol, the tables are not too bad however I do plan on getting something a little strong someday.

    I have to confess that a couple of these are going to their forever home soon and it's not here :( lol.
     
  4. gonzalo

    gonzalo Well-Known Member

    Joined:
    Mar 17, 2016
    Messages:
    165
    Likes Received:
    93
    What's on the wall!? You already had a fire???
     
  5. gonzalo

    gonzalo Well-Known Member

    Joined:
    Mar 17, 2016
    Messages:
    165
    Likes Received:
    93
    Only when you see a BB parked next to a i3 you realize how HUGE it really is.
     
    Miasmictruth likes this.
  6. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    No lol, I should probably get one for that room, there was never one in there when I bought the house, I shall remedy that soon.

    It's a little wooden hatchet just decoration, not sure where it came from I had it since I was a kid.

    I probably should have picked up before the photo lol but I was exhausted after finishing the building, calibrating, and testing of two MK2's in 5 days while working a full time job lol.

    On a bonus, that is a duet wifi and duex5 sitting on the desk between the real prusa and the knockoff, which is now it my bigbox. It's wired but I haven't had a chance to sort out the firmware.
     
    #6 Miasmictruth, Feb 19, 2017
    Last edited: Feb 19, 2017

Share This Page