No mesh bed levelling in Alex's single-head (V1.1 Hybrid Pro) firmware?

Discussion in 'Calibration, Help, and Troubleshooting' started by Hans C., Dec 18, 2016.

  1. Hans C.

    Hans C. Well-Known Member

    Joined:
    Dec 21, 2015
    Messages:
    129
    Likes Received:
    43
    I recently turned my Dual Titan V1.1 into a single and re-flashed the firmware, but the bed-levelling routine isn't working the same. Instead of hitting 9 points and allowing me to fine-tune each, the head moves to the 4 corners and says it's done. Is there a more recent version, or a way to add proper mesh bed levelling to the firmware?

    (In case there was any doubt: I'm a dweeb when it comes to electronics, which is why I decided to try to simplify my BB. So far it isn't going quite as planned. :confused:)
     

Share This Page