Not Printing

Discussion in 'Calibration, Help, and Troubleshooting' started by MJ Farley, Apr 28, 2016.

  1. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    391
    Yep, experienced the same thing when my pi hung due to a bad image of octopi. Very weird behavior (I suspect a rumba USB bug where it is waiting for some sort of ack OR total failure to detect if nothing is connected, but the middle state of something with a USB port is connected but since the OS isn't up yet isn't answering, causes it to stay in some sort of wait state.
     
  2. MJ Farley

    MJ Farley Member

    Joined:
    Apr 15, 2016
    Messages:
    10
    Likes Received:
    2
    Thank you so much!!! That seems to have been the problem. I removed the Raspberry Pi SD card and just tried the calibration file and it works now. Hopefully E3D will make a troubleshooting guide from all of these threads and add it to the build manual, so that future builders will have an easier time. And thanks to everyone else who tried to diagnose the cause too... they may not have been the solution to my problem, but may be to anyone else who may be stuck. :D
     
    wfredette likes this.
  3. wfredette

    wfredette Well-Known Member

    Joined:
    Jan 11, 2016
    Messages:
    89
    Likes Received:
    25
    Woot! Now go make a tugboat!
     

Share This Page