Nozzel Height?

Discussion in 'Troubleshooting' started by RonRock, Feb 16, 2021.

  1. RonRock

    RonRock New Member

    Joined:
    Feb 15, 2021
    Messages:
    1
    Likes Received:
    0
    Sorry this is a poor question, but I can not find the answer.

    I have been given an XYZ Da Vinci 1.0a that needed a new hot end. I purchased and installed a E3d v6. The Da Vinci had previously been flashed with Repetier 0.92 firmware. So with the new hot end and the flashed firmware I have no OEM documentation to rely on.

    After much trial and error I am able to make a print. But I think that it can be better. I have leveled the bed and set my Z minimum at .50mm.

    Is there a figure that I should set my Z min at? .50 mm was a guess on my part.
     

Share This Page