Nozzle ident numbers

Discussion in 'E3D-v6 and Lite6' started by UKIan, Sep 30, 2014.

  1. UKIan

    UKIan Member

    Joined:
    Sep 7, 2014
    Messages:
    10
    Likes Received:
    0
    Hi again. I've posted about this over on the reprap forums. I thought a nozzle was larger than it should be. Apparently there are numbers printed on the flat of the hex if the nozzle which map to a lookup table of sizes. Mine is number free (v6 hotend) . Checked the nozzles on my kraken ad well, no numbers.

    Any ideas?
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    586
    Likes Received:
    91
    There are no numbers. There are dots. This is covered in the documentation.
     
  3. UKIan

    UKIan Member

    Joined:
    Sep 7, 2014
    Messages:
    10
    Likes Received:
    0
    Yes, it was linked on the RepRap forum and I assumed it meant the number marked on the side, not the number of marks. I did specifically mention the dots.
     
  4. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    586
    Likes Received:
    91
    Again, there are no numbers printed on the side of the nozzle. There are dots, and you count up how many are present on the nozzle.

    You said nothing of "dots" in your original post. You said yours is "number free". I have no idea what this means.
     

Share This Page