nozzle questions

Discussion in 'BigBox General Chat' started by Henry feldman, Nov 13, 2015.

Tags:
  1. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    389
    So for folks with V6 (or other I suppose) experience with the hardened nozzles. Does one just leave them on even if you are not using filled filaments, or do you swap them out for brass nozzles unless you need the hardened ones.
     
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    444
    Likes Received:
    89
    I would personally stick with brass in the event of a clog. A lot cheaper to replace in that regard.
     

Share This Page