OcotPrint- Camera not working? Do I need to undo everything to get to cable?

Discussion in 'Calibration, Help, and Troubleshooting' started by Pierce, Mar 20, 2016.

  1. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    249
    Likes Received:
    67
    Commissioning my octoprint today and got everything working but the camera, anyone got any troubleshooting sheets or top tips of how to get at the electronics easily?

    Or am I going to have a bad day and undone the entire base to check the cable?
     
  2. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    249
    Likes Received:
    67
    30 minutes later.... Opened base, didn't have to undo every bolt, managed to leave the last 5 and just loosen them and use it to pivot.

    Raspberry pi connection was plugged in wrong way, switched and all working (I tested before I put the base back on this time!)
     
    Mike Kelly likes this.

Share This Page