OctoPi Calibration (GCODE Scripts)

Discussion in 'Calibration, Help, and Troubleshooting' started by Old_Tafr, Apr 1, 2016.

  1. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    561
    Likes Received:
    75
    The GCODE scripts section says

    To "After print job is cancelled" add;

    ;dock
    G1 X70 Y200 F3000
    G1 X70 Y240 F3000


    As there are commands ALREADY in this box, are the commands above to REPLACE the existing commands? added BEFORE them or added AFTER them?

    The other boxes are empty so it's just copy and paste (not the full stops though)
     
  2. Kick2box

    Kick2box Well-Known Member

    Joined:
    Mar 15, 2016
    Messages:
    198
    Likes Received:
    27
    In doubt before, at least before M84
     

Share This Page