I am fairly new to 3D printing and have inherited an original kickstarter BigBox Pro with a raspberry Pi in it. I found that the octoprint SD card was corrupted and ive had to reinstall octoprint. I am now looking for the settings for octoprint as the original build manual seems to have dissapeared. Any help would be appriciated.
Original Octopi info from E3D found be using duckduckgo.com search terms "octopi E3D" https://wiki.e3d-online.com/BigBox_OctoPrint_Upgrade This WiKi also points to the later instructions, which I have not searched for "Octopi"
Hi Old_Tafr Thanks for that link. I had seen that wiki before but when I started trying to setup octopi I couldn't find it anymore. I will try and set the printer up with the information from the wiki. Martin
From a distant memory I don't remember many hiccups when following the instructions to a t. The one thing I vaguely remember and it will be in post here was that I had either got my wires crossed (actual physically ) or a setting wrong and up became down or move left sent the head right, this was fixed with a setting in Octoprint. As there are controls in the interface then testing this sort of thing should be easy.
This was the post... https://forum.e3d-online.com/thread...g-octoprint-z-movement-counter-intuitive.999/