Optimal settings for Titan+E3D V6

Discussion in 'Titan' started by Hatmpatn, Feb 1, 2017.

  1. Hatmpatn

    Hatmpatn Member

    Joined:
    May 4, 2016
    Messages:
    3
    Likes Received:
    1
    Hello! I would like to know what settings you guys run for your E3D Titan + E3D V6 setup?

    Extruder motor:
    Extruder stepper driver:
    Extruder stepper driver Vref:
    Extruder steps/mm:
    Extruder acceleration:
    Extruder jerk:
    Retract distance:
    Retraction speed:

    And maybe post a picture of your most successful print(maybe a 3DBenchy?).

    If E3D themselves want to answer they are more than welcome!
     
  2. Cedric_K

    Cedric_K Member

    Joined:
    Jan 16, 2017
    Messages:
    22
    Likes Received:
    10
    Extruder motor: 17HS6002-N27B
    Extruder stepper driver: RAPS128
    Extruder stepper driver Vref: 1.367v (1.24A)
    Extruder steps/mm: 404
    Extruder acceleration: 3000
    Extruder jerk: N/A
    Retract distance: 5
    Retraction speed: 45

    Very high torque (65Nm), low inductance(6.5mH), low current (1.8A) motor, good for speed, but maybe not the best for acceleration.
    Underdriven (1.24A), give cold running, enhances acceleration. Maybe i loose torque, but there is enough torque left so you will jam your nozzle and grind your filament if your nozzle height is too low.
     

    Attached Files:

  3. Alejandro

    Alejandro New Member

    Joined:
    Mar 20, 2017
    Messages:
    1
    Likes Received:
    0
    Direct or bowden ?
     

Share This Page