Part Cooling fan mount (Hybrid Dual) upgrade solutions :)

Discussion in 'Guides, Mods, and Upgrades' started by cez, Apr 1, 2019.

  1. cez

    cez Well-Known Member

    Joined:
    Apr 4, 2016
    Messages:
    131
    Likes Received:
    23
    The part cooling fan mount on the Bigbox Hybrid dual isn't the best for pla. I've printed out this design here in Edge but it warps under the heat of one hotend https://www.thingiverse.com/thing:1731426

    what are you guys using? does anyone have a better design solution?
     
  2. Stefan

    Stefan Well-Known Member

    Joined:
    Feb 17, 2016
    Messages:
    324
    Likes Received:
    43
    Hi not sure if you are still looking, but I use this design in Edge too but I have a Silicon sock on my block.
    bye
     

Share This Page