Part Cooling Fan - Wiring

Discussion in 'Build Help' started by Spoon Unit, Oct 26, 2016.

  1. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,095
    Likes Received:
    322
    The black wire on my part cooling fans have now both snapped off. I think the problem is that, while the white wire is nicely captured under a piece of plastic, the black wire floats free and thus whenever you make a change to the system has a chance to snap the very dainty soldering.

    After re-soldering it, I had the idea to use a piece of filament to jam into the hole. I don't think the black wire will come free again. I used a piece of green Edge filament, but you can use any 1.75mm colour you like if you feel like securing your wires in the same way.

    ApplicationFrameHost_2016-10-26_08-15-32.png
     

Share This Page