PETG retraction settings

Discussion in 'Calibration, Help, and Troubleshooting' started by TstarkEngineering, Apr 21, 2016.

  1. TstarkEngineering

    TstarkEngineering Well-Known Member

    Joined:
    Jan 29, 2016
    Messages:
    450
    Likes Received:
    120
    Im not have very good luck with stopping the ooze using PETG, does anyone have any insight to retraction settings to help reduce this.

    Here is my current settings still with not very much luck.
    [​IMG]

    Thanks
     
  2. Kick2box

    Kick2box Well-Known Member

    Joined:
    Mar 15, 2016
    Messages:
    198
    Likes Received:
    27
    Retract 1.2mm at 40mm/s, no vertical lift, Wipe Nozzle = Yes, 5mm is ok, underextrude a little bit and print slow.
     

Share This Page