TEVO Tarantula Pro ED3 V6 genuine My Volcano was prone to leaking from day one and I was tired of rebuilding it every few prints. Yes, I know how to rebuild them as I have run 2 standard TT for a year with no issues. I had a ED3 V6 installed on one of my Tarantula and it was installed with no issues using Marlin Easyconfig for TEVO. I have Marlin_2.0.0_TTPro_Standard now and when ever I set a temp it insanely goes over temp within seconds. If I set it to 200 then typically the max alarm goes off as it hits 285 before starting to settle down. Once it cools it keeps within a few degrees of 200. I tried to PID tune it and it overshoots ;within seconds every time and fails. Send: M503 Recv: M301 P26.27 I2.49 D69.41 Send: M303 E0 S200 C3 Recv: PID Autotune failed! Temperature too high Any help would be appreciated.
I did just fine PID_MAX define, which is normally set to 255 but with my 40w heater that it some people are better with around 160. I will try that out.