plated copper block

Discussion in 'E3D-v6 and Lite6' started by sergey stephanian, Oct 28, 2018.

  1. sergey stephanian

    Joined:
    Sep 10, 2018
    Messages:
    8
    Likes Received:
    2
    unfortunately the nickel plating came off after around 30-50 hrs of print . print temp was never above 400c .
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    614
    Likes Received:
    100
    Picture?
     
    Antoine likes this.
  3. sergey stephanian

    Joined:
    Sep 10, 2018
    Messages:
    8
    Likes Received:
    2
    i'm sorry , its my mistake .
    i saw lots of chipping from the copper block , the chips looked like thin glass ,i thought it was part of the nickel plating .
    today i removed the printer from the enclosure and cleaned the block . i think the block is still ok . the chips were probably ultem residue that was stuck on the block .
    the plating only has some discoloration .
    after some cleaning :
    20181029_222640.jpg
    sorry again
     
    Antoine likes this.

Share This Page