Hello I replaced the original hotend at my RF1000 (using repetier-master FW) with an E3D hotend. Now I had to flash the printer with the latest FW. At an earlier firmware there was a sensor table integrated in the configuration.h file so I expected to only have to change the sensor number as it is described in the E3D wiki. But surprisingly the new configuration.h has no such table. I only found a temperature/resistance table as a sample using 4 !! values in every entry. Where can I find the correct table for the 104GT-2 and what must I do to configure it correctly? Can anybody help please? Thank you in advance for any help Regards Peter