Print quality problem

Discussion in 'Calibration, Help, and Troubleshooting' started by James Peel, Apr 9, 2017.

  1. James Peel

    James Peel Well-Known Member

    Joined:
    Nov 4, 2016
    Messages:
    47
    Likes Received:
    2
    having a weird qualiry issue - layer height 0.15mm - havent had any problems like this before :/ - HELP
     

    Attached Files:

  2. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    362
    Likes Received:
    124
    That looks like under extrusion. I suppose you did calibrate the filament you are using. If you did, then your nozzle could be clogged. Did you recently change to a filament with a lower melting temperature ? If so, there could be some old (higher temperature) filament left in you nozzle. Crank up the temperature of your hotend and extrude 10cm or more. This will (hopefully) solve your problem.
     

Share This Page