Print speed

Discussion in 'BigBox General Chat' started by NinjaLars, Jul 2, 2016.

  1. NinjaLars

    NinjaLars Active Member

    Joined:
    Feb 27, 2016
    Messages:
    27
    Likes Received:
    3
    I'm about to build my bb soon and wonder what print speeds that are possible to achieve with maintained quality?
     
  2. GrodanB

    GrodanB Well-Known Member

    Joined:
    Feb 3, 2016
    Messages:
    193
    Likes Received:
    26
    I would say 60mm/s and the ringing seems that it is gone... if the ringing is not a problem then 100mm/s is not a problem.

    Also a very stable surface seems important. My table flexes... and each time I lean on the table I get a line in the print.

    I plan to build a torsion box for the printer to stand on so no flex from the table happen.

    I assume that the problem was that one corner of the printer became lower than the rest.
     

Share This Page