Printer Commissioning step missing

Discussion in 'Calibration, Help, and Troubleshooting' started by Rob Heinzonly, Mar 1, 2016.

  1. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    448
    Likes Received:
    174
    Tomorrow I will be ready for commissioning my printer. I have one big question: in the BigBox Printer main assemblies, in chapter 13 (Frame Top assembly), the first thing you do is finger-tighten the four screws (two on the X-Axis Idler & two on the X-Axis Motor Mount) clamping the X-Axis bearings. During Commissioning I nowhere can find where they are fastened again. It would make sense that this should be done after chapter 1.2 in Commissioning, after the positioning of the X-axis to the front of the frame. Am I right about this ?
     
  2. Chase.Wichert

    Chase.Wichert Well-Known Member

    Joined:
    Mar 1, 2016
    Messages:
    775
    Likes Received:
    208
    I believe you are correct.
     

Share This Page