Printheads miss dump bucket after aborted print

Discussion in 'Calibration, Help, and Troubleshooting' started by pSimon, Oct 23, 2016.

  1. pSimon

    pSimon Member

    Joined:
    Sep 27, 2016
    Messages:
    23
    Likes Received:
    0
    An undesirable effect I've noticed:

    If you stop a print from the control panel, and then start it again [as opposed to a resume], when the heads move to the dump bucket, they miss, hitting the back on the right, as if the head offset is applied twice (or something).

    If a print completes normally, a successive print is ok.

    I'm using Alex's RC7 dual MBL firmware, and (I think) the latest profiles.

    Has anyone else experienced this?
     

Share This Page