Probe Offset?

Discussion in 'Calibration, Help, and Troubleshooting' started by Syko_Symatic, Jan 10, 2017.

  1. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    348
    Likes Received:
    78
    I don't know if it matters but I noticed that there is no y axis probe offset in my config. Now it would obviously be better if the position was correct but I out in the +offset (the probe is behind the head) but it went crazy. Didn't try and move to the safe homing position it just stayed at the 0,0 and tried homing the z there!

    Is there something I need to adjust?

    My next thing, to throw it in as well is that my bed is being probed as having a 2mm slope that does not exist. I have checked again and again and it is level. It has to be the axis right?
     

Share This Page