Problems with E3D v5

Discussion in 'E3D-v6 and Lite6' started by MrIvorVra, Aug 10, 2015.

  1. MrIvorVra

    MrIvorVra New Member

    Joined:
    Aug 10, 2015
    Messages:
    1
    Likes Received:
    0
    I got terd and wanted to take a break from the printer. My dad took over the project and
    these are pictures i took from his time wit it.
    We are using cura for slicing and repetier and k8200 printer. 3mm PLA with a 0.4 mm nozzle.


    We are also getting this black goop that is ruining our prints and our x axis sometimes moves
    when the printer starts printing a new layer.
    If you are using similar rig could you please share settings and experience.
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    586
    Likes Received:
    91
    Looks like quite a lot of leakage, indicating it was not assembled properly.

    Disassemble, clean, reassemble with E3D's instructions. Also use the fan duct.
     

Share This Page