Problems with z-height but not on first layer

Discussion in 'Tool heads & ToolChanger' started by Demi Urgen, Jan 20, 2023.

  1. Demi Urgen

    Demi Urgen Member

    Joined:
    Jan 20, 2023
    Messages:
    2
    Likes Received:
    0
    Hi
    I am trying to calibrate a newly built ToolChanger and I am slowly getting there.
    After getting a pretty good first layer with z calibration I did the x and y calibration and everything was looking good.

    Then I tried to print my first print with more than one layer. A calibration cube of 1x1x1cm.
    Layer height is set to 0.2 in the print settings and min layer height limit is 0.07 in the printer settings.
    Nozzle diameter is 0.4.

    The cube ended up like this:
    IMG_0102.jpeg
    What am I doing wrong?
    Is this z-height?
    Is it E-steps?
    Does anyone have any ideas?

    The STL was downloaded from Thingiverse and sliced with Prusa slicer using the profiles found here:
    https://toolchanger.xyz/SlicerProfiles.html
     
  2. dc42

    dc42 Well-Known Member

    Joined:
    Aug 16, 2016
    Messages:
    526
    Likes Received:
    221
    It looks to me that your Z steps/mm is set too high. What Z steps/mm have you set in the M92 command in config.g, and what is the pitch and lead of the Z leadscrew?
     
  3. Demi Urgen

    Demi Urgen Member

    Joined:
    Jan 20, 2023
    Messages:
    2
    Likes Received:
    0
    YES!!! That was it. Thank you!
     

Share This Page