Profile for hemera

Discussion in 'HotEnds & Extruders' started by Eran Arviv, Feb 29, 2020.

  1. Eran Arviv

    Eran Arviv Member

    Joined:
    Feb 29, 2020
    Messages:
    2
    Likes Received:
    0
    Hi,
    Im using duet wifi 2 with the hemera direct on my diy BLV cube and i am starting to give up..
    The quality worse then my original v6 bmg clone that cost 1/10 the cost of the hemera and with 70 cm Bowden..
    So before I say rip to my 100+ gbp it cost is there someone who is willing to share he's acceleration and jerk and profile to simplify3d/cura that works good for him using the direct hemera?

    It's really sad that there are much more support for Chinese knockoffs that cost nothing.
     
  2. Thorinair

    Thorinair Well-Known Member

    Joined:
    Aug 8, 2017
    Messages:
    50
    Likes Received:
    7
    I use 800 accel for outer (visible) perimeters and skins, 1600 for all inner. Using Junction Deviation instead of jerk. These settings depend on your printer alone, and you should try to calibrate them using a print like this: https://www.thingiverse.com/thing:277394
    Regardless, Hemera is supposed to print amazingly well with any kind of stock settings. If it is not, then it is most likely a user error, for instance, maybe you forgot to change the steps/mm and correctly calibrate it, or forgot to adjust the current of the motor.
     

Share This Page