PT100 Amplifier Board and Rambo Board

Discussion in 'General' started by Franz, Nov 27, 2015.

  1. Franz

    Franz New Member

    Joined:
    Nov 24, 2015
    Messages:
    1
    Likes Received:
    0
    I own a Lulzbut Taz 4 printer and I'm interested in upgrading it with a PT100. I read on the documentation that the positive must be connected to the 5V on Aux1, negative pin on the gnd of the board and the signal pin to the A3 pin. To get the extruder reaching higher temperature, should I also mount a thermocouple or just using that board?
     

Share This Page