PT100 Temp sensor/Duet PT100 Daughterboard

Discussion in 'Getting Started' started by Sir Hattington, May 15, 2020.

  1. Sir Hattington

    Sir Hattington New Member

    Joined:
    May 15, 2020
    Messages:
    1
    Likes Received:
    0
    Howdy,

    I am currently building my toolchanger and have run into a slight roadblock. I got the PT100 sensors and daughter boards but should I use the sensor cabling that is wired into the wiring loom kit and just make a jumper from the end connector to the DB or just use the wiring that came with the PT100 sensors?
     
  2. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,546
    Likes Received:
    481
    I just used a couple of connector pins, plugged into the connector from the wiring loom, and screwed those into the daughterboard.
     
  3. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,546
    Likes Received:
    481
  4. Jonas

    Jonas Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    71
    Likes Received:
    31

Share This Page