Making another thread so I don't spam the previous one I made with unrelated stuff. I am assembling the E3D v6 1.75 mm bowden hot end (ordered from the official store), and I can't push the PTFE in for the death of me. I tried to push it in without the heat break screwed in, just to see how deep it can go, and it barely goes in half way. Any suggestions? I thought it should go in a bit easier than that. EDIT: Is my PTFE defective or something? I can't even see a way to properly push it into the pushfits. EDIT 2: The PTFE's thickness appears to be something like 4.12 mm or so, if that means anything.