Repetier Host/ Davinci AIO problem

Discussion in 'General' started by Lennie, May 28, 2016.

  1. Lennie

    Lennie Member

    Joined:
    Dec 4, 2015
    Messages:
    10
    Likes Received:
    1
    I have a flashed Davinci AIO and recently I changed the hotend to an E3d v6. After many hours of Breaking and fixing, this is the problem I've come down to. When I run Repetier host and I click on the button to heat the extruder, the "pause printing" window pops up. I look over at my da Vinci screen and it says no filament loaded or something to that effect. I press enter on my da Vinci panel and extruder starts to work. Then it'll bring me to a load unload screen but whenever I tried to run Repetier again, The pause printing window pops up again and I go through the same cycle. I'm running 0.92 firmware. I can't figure this one out. Please help.
     
  2. mike01hu

    mike01hu Well-Known Member

    Joined:
    Apr 22, 2014
    Messages:
    957
    Likes Received:
    166
    You may get more help at the Repetier forum here but I assume you get temperature indications on Repetier and that they are correct.
     
  3. Lennie

    Lennie Member

    Joined:
    Dec 4, 2015
    Messages:
    10
    Likes Received:
    1
    Problem solved. I shut off the filament sensor in my Da vinci settings
     
    mike01hu likes this.

Share This Page