What are your ideal Ooze Control Settings in Simplify3D for the E3D V6 (Gold) ALL METAL Hotend on a CR10S with Bowden Setup (Capricorn XS)? A) For PLA (210°C) B) For PETG (>230°C) ... I started with Chris Elkins CR10 Profile but found out that it is not recommended to go over 2-3mm for the all metal due to danger of clogging ...
I haven't got different settings for PLA and PETG, and no longer configure ooze control through S3D, but instead using the Duet's inbuilt retraction control. That said, I would configure those numbers like this in order to duplicate my Duet settings: Retraction Distance = 1.5mm Extra Restart = 0.1mm Retraction Vertical Lift = 0.2mm Retraction Speed = 90mm/s Then I would turn off coast at end and wipe.
Retraction Distance = 1.5mm .... for a Bowden Setup? Do you have the all metal version? I tested the following Settings with quite disappointing results.