Round objects not round

Discussion in 'Motion System' started by TstarkEngineering, Jan 19, 2022.

  1. TstarkEngineering

    TstarkEngineering Well-Known Member

    Joined:
    Jan 29, 2016
    Messages:
    484
    Likes Received:
    130
    I am mainly getting outer layers of round objects ovalized. to where at 2 points 180° apart there is seperation between each extrusion path. I have tried loosing up all the belts and it over exaggerated the problem, however with proper belt tension it doesn't make it go away. Suggestions?

    Thanks
     
  2. Greg_The_Maker

    Greg_The_Maker Administrator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    1,035
    Likes Received:
    632

Share This Page