Scaffold

Discussion in 'BigBox General Chat' started by Falc.be, Apr 18, 2016.

  1. Falc.be

    Falc.be Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    244
    Likes Received:
    38
    I am about to start using scaffold and I am wondering if anyone has any pointers on settings (retraction, ...)

    Also has anyone used it together with XT ?
     
  2. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    Yup, XT works good, better than PLA/PHA.
    I used same settings as if I would print PLA/PHA, 210° C, 1.5mm retraction at 70mm/s (stock E3D profile settings).
    The build plate I heated for XT, 75° C, but that could depend on how the areas of XT to Scaffold are distributed. Maybe less is you have only Scaffold on the build plate...
     

Share This Page