senzor problems

Discussion in 'Calibration, Help, and Troubleshooting' started by wito, Jul 12, 2017.

  1. wito

    wito Member

    Joined:
    Jul 12, 2017
    Messages:
    2
    Likes Received:
    0
    ey folks, i have a question about the e3dv6, i have instaled it today, but the sensor shows that the temperature is 0° when i heat it up i get a instant runaway message. ive updated the firmware to the semitec senzor but still get that error, anyone here can help me?
     
  2. wito

    wito Member

    Joined:
    Jul 12, 2017
    Messages:
    2
    Likes Received:
    0
    used a multimeter and unplugged i get nothing on the ohm scale, but plugged in i get a -68.7 reading
     

Share This Page