SOLVED Set/Grub Screw for Hybrid X-Carriage

Discussion in 'Build Help' started by Scott Carlson, Jun 8, 2016.

  1. Scott Carlson

    Scott Carlson Member

    Joined:
    Nov 29, 2015
    Messages:
    16
    Likes Received:
    3
    Hello Everyone --

    Missing a M4 12mm grub screw (To trap the extruder), just found an M4 10mm at the local hardware store. Any reason this would not work? I'm sure it will become obvious as I progress, but thought I'd ask?

    Thanks in Advance,
    Scott
     
  2. R Design

    R Design Well-Known Member

    Joined:
    Oct 7, 2015
    Messages:
    918
    Likes Received:
    183
    Mine looks like it's sticking out 2mm or LESS. So your 10mm may be too short.

    Better too long. (And you can always cut it down.)
     
  3. Scott Carlson

    Scott Carlson Member

    Joined:
    Nov 29, 2015
    Messages:
    16
    Likes Received:
    3
    Thanks for the advice. It turns out the correct grub screw was in the overflow bag (among other items).

    Build is complete (performing alignment now), and every single component was here. Nothing missing!

    Scott

     
    PsyVision likes this.

Share This Page