Hey! I fail to set the retraction value in my E3D toolchanger I use the SuperSlicer and was used to Prusa to set it in the slicer. For this I did the "retraction_calibration" in Super-Slicer. The tower always looks the same, not as usual with a change the further up it goes. The last step should be 1.5mm which should really be enough for a Direct Extruder to show a difference. Now to my question. Is there still a setting/firmware setting that changes the retraction value? Also the firmware retraction does not want to work completely. G10/G11 in conjunction with M207 S0.0 P0 R0 F2400 T2400 Z0.0 Am I missing something? Thanks a lot Printer: E3D-Toolchanger Tool: Hemera Tool Board: Duet 2 WiFi (2WiFi) Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.1.1 (2020-05-19b2) Version von Duet WiFi Server: 1.23
