Settings Required in Simplify3D for BigBox?

Discussion in 'Calibration, Help, and Troubleshooting' started by Old_Tafr, Apr 5, 2016.

  1. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    731
    Likes Received:
    93
    There does not appear to be as yet a BigBox (single or dual) config for s3d.

    Has anyone written down what has to be configured, added, etc. in s3d for the BB dual?
     
  2. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    251
    Likes Received:
    68
  3. Steven Burns

    Steven Burns Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    195
    Likes Received:
    55
    It is on the last page or two
    On the last page or two of the assembly guide/wiki there are links to the pro and dual versions for Simplify and Slic3r.
     
  4. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    731
    Likes Received:
    93
    Added this (thanks ! ) what I'm also looking for is where to add the X & Y offset between nozzles calculated during setup and what and where to add the code to wipe the nozzles immediately before printing commences....... Plus anything else handy like that.
     
  5. Pierce

    Pierce Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    251
    Likes Received:
    68
    Nozzle wipe code is under OctoPrint commissioning if you want to grab it from there?
     

Share This Page