Should I level the bed before each print?

Discussion in 'Calibration, Help, and Troubleshooting' started by Syko_Symatic, Mar 17, 2016.

  1. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    365
    Likes Received:
    106
    I have been having problems with the Z-height. Every time a print fails (I have only managed to complete 1 for many reasons) if I reboot and restart the bed seems to lose its position and I have to level it again. Id this normal or am I missing something?
     
  2. PsyVision

    PsyVision Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    798
    Likes Received:
    248
    After you do "Level Bed" are you then using the "Store memory" option??
     
  3. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    365
    Likes Received:
    106
    Nope! Guess that is where I am going wrong! I assumed (and you know what that word does) it would store it automatically. IDIOT! Will have to do this one later. Sorry, moron alert ;)
     
  4. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,411
    Likes Received:
    735
    I had the same problem... I am a bit spoiled by my UM2...
     

Share This Page