Should sell the Molex Microfit 3 connectors compatible with your fans, heaters, and thermistors.

Discussion in 'HotEnds & Extruders' started by John Meacham, Dec 18, 2020.

  1. John Meacham

    John Meacham Well-Known Member

    Joined:
    Dec 18, 2019
    Messages:
    70
    Likes Received:
    24
    Although the 1x2 microfit connectors (with the latch on the small edge) are quite common, the single row 2x1 versions (with the latch on the long edge) used on e3d stuff are surprisingly hard to come by. It would be cool if the store stocked them.
     
  2. Michael Coar

    Michael Coar Member

    Joined:
    May 23, 2021
    Messages:
    2
    Likes Received:
    0
    Hi, I've got a large printer build, and I would like to make a long cable with this connector, so I can make it in one long piece, without any splices.

    Can someone please help me with a source in the US, where I can get these connectors and pins.

    Thanks.
     

Share This Page