Simplfly 3d Settings

Discussion in 'E3D-v6 and Lite6' started by John Sandlin, Feb 21, 2019.

  1. John Sandlin

    John Sandlin New Member

    Joined:
    Feb 21, 2019
    Messages:
    1
    Likes Received:
    0
    So I have an Ender 3 Pro E3DV6 (No clone here), EZABL, Raspberry PI 3 B+, Upgraded Metal Extruder, TFT 32, MKS Gen l 8729 stepper drive on the extruder and a Petsfang duct. YES ALL THIS IS ON A ENDER 3 I'm using ESUN filament, I'm getting some clicking on the extruder. So I want to make sure I have the proper setting on Simplfy 3D. Here is a picture of a first layer. Any help would be great. Thanks everyone
     

    Attached Files:

    #1 John Sandlin, Feb 21, 2019
    Last edited: Feb 21, 2019

Share This Page