Simplify 3D Settings for Hemera Direct Drive setup and standard hot end...

Discussion in 'HotEnds & Extruders' started by Tony MacDonald, Dec 14, 2019.

  1. Tony MacDonald

    Joined:
    Dec 14, 2019
    Messages:
    8
    Likes Received:
    7
    I recently installed my new Hemera direct drive with the standard hot end on my CR-10S

    The mount I used is here: https://www.thingiverse.com/thing:4030098 and it's great but use my remixed fan mount or that part wont work. This is the best one out there for the CR-10/CR-10s or Ender3 right now.

    I'm looking for some assistance in fine tuning the settings for my Hermera in Simplify3D

    I have my retractions set to .7 mm (still tuning here)
    But have questions about wipe distance and coast.
    My E steps/mm is set at 404 and my Extrusion multiplier is set at .99mm

    Does anyone have any advice on changes that I should make. Prints are ok but there is room for improvement.
     
  2. Daniel Rock

    Daniel Rock Well-Known Member
    Staff Member

    Joined:
    Jul 9, 2018
    Messages:
    97
    Likes Received:
    10
    Pictures would be the easiest method of troubleshooting for print quality, you also have to bear in mind if you are now using a Direct Drive Hemera you will no longer need to overcompensate with your wipe and coast settings, you may be better off turning them off, to begin with, starting with low values if you feel they are required. Hemera is far more responsive than Bowden setups, so the slicer compensation for lag is most liely not required
     
    Mohcine likes this.
  3. Mohcine

    Mohcine Member

    Joined:
    Jan 18, 2020
    Messages:
    14
    Likes Received:
    2
    Hi Tony,

    I have also ordered the Hemera direct drive and I will receive soon.
    It is my first "direct drive".
    I am interested by your Simplify configuration.
    Could you please share them (screen capture for example) ?
    It fill be helpfull.

    Thanks.
    Best regards.
     

Share This Page