Software profiles

Discussion in 'BigBox General Chat' started by Dr Jeep, Dec 28, 2015.

  1. Dr Jeep

    Dr Jeep Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    530
    Likes Received:
    169
    Is it me...or are we a bit behind on getting software profiles for the BigBox ? I'd have expected it appear as a standard Simplify3D profile by now given the collaboration in terms of selling Simplify and wasn't the print farm using it ?

    With 50 printers shipped and at least one in operational condition now, isn't it about time the profiles were out there ? Are they being privately shared with the early backers and still being debugged ?

    Or are they out there already and I just haven't noticed ?
     
    Yakiimo and Halvard Fosse like this.
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    444
    Likes Received:
    89
    Privately shared so far and their dual profile isn't finalized yet.

    It'll be pushed in the next revision of simplify3d.
     
  3. SoBaldrick

    SoBaldrick Well-Known Member

    Joined:
    Sep 15, 2015
    Messages:
    99
    Likes Received:
    66
    The profiles are included in the build manual, S3D and Slicer, only alpha so far.
     

Share This Page