Solidoodle 2 pro with e3d v6 head blockage

Discussion in 'Calibration, Help, and Troubleshooting' started by Robert Downs, Mar 7, 2017.

  1. Robert Downs

    Robert Downs New Member

    Joined:
    Mar 7, 2017
    Messages:
    1
    Likes Received:
    0
    Morning all,
    I'm having a bit of issue with this head, I get a print or two out if I clean with acetone but if I let it cool down then I get a blockage. I am printing with ABS and have changed the retraction to 0.5 mm and I am printing at 225 deg C. I have attached a few pictures so you can see what the setup is and how deep the blockage goes.

    Cheers
    Rob

    [​IMG]
    [​IMG]

    [​IMG] [​IMG]
     

Share This Page