Spine & PTFE

Discussion in 'BigBox General Chat' started by xreymason, Mar 3, 2016.

Tags:
  1. xreymason

    xreymason Member

    Joined:
    Mar 1, 2016
    Messages:
    16
    Likes Received:
    0
    What holes is it talking about on Cable Spine Assembly that I should check to see if the PTFE fits through? I only see the swirly holes but I don't think those are the holes it's talking about.

    This is what it says:
    "Note: Check the PTFE feed tube runs smoothly through the holes in the printed parts. If it is too tight run a 4mm drill through the holes."
     
    #1 xreymason, Mar 3, 2016
  2. Steven Burns

    Steven Burns Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    195
    Likes Received:
    55
    Yes, those are the correct holes. You may need to file them a bit for the tube to fit.
     
    #2 Steven Burns, Mar 3, 2016
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
    Yeah the swirly-ness is for it to sort of clamp on the tube a bit
     
    #3 Mike Kelly, Mar 3, 2016
(You must log in or sign up to post here.)

Share This Page