Stainless vs Titanium heatbreak

Discussion in 'E3D-v6 and Lite6' started by themaninthesuitcase, Oct 15, 2021.

  1. themaninthesuitcase

    themaninthesuitcase New Member

    Oct 15, 2021
    Likes Received:
    I just had to strip my V6 due to a filament leak and so have to rebuild.

    I have the option of the standard Stainless Steel and a Titanium heat break, both are genuine E3D.

    Is there any reason not to use the titanium?

    The leak was using the Ti heatbreak but I noticed the nozzle was solid against the block so clearly something went wrong during assembly.

Share This Page