Start-up blockage

Discussion in 'E3D-v6 and Lite6' started by sungod3k, Nov 24, 2014.

  1. sungod3k

    sungod3k Active Member

    Joined:
    Aug 25, 2014
    Messages:
    26
    Likes Received:
    1
    Hey,

    I had quite the learning curve with my V6 and Im slowly getting the feel for it.
    Something that came up recently is that in 25% of my prints the nozzle blocks when I start printing. Its easily fixed by just pulling out the bowden tube an inserting the filament back in and the plug also doesnt look much different.
    The rest of the print runs smoothly. Anyone notice anything similar?
     

Share This Page