Suggested G Code & firmware settings

Discussion in 'Multi-Extrusion' started by paultnl, Aug 28, 2015.

  1. paultnl

    paultnl Member

    Joined:
    Aug 17, 2015
    Messages:
    21
    Likes Received:
    0
    Hi,

    I have recently upgraded my Prussa I3 to dual extruders but have only had limited success using cheap J heads so I have just ordered a Chimera. Does anyone have any examples of firmware settings or G-Code to be used during switching.

    Thanks,

    Paul
     
    #1 paultnl, Aug 28, 2015
  2. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
    The chimera doesn't need anything special during switching as long as you have the offset and retractions properly defined
     
    #2 Mike Kelly, Aug 28, 2015
  3. paultnl

    paultnl Member

    Joined:
    Aug 17, 2015
    Messages:
    21
    Likes Received:
    0
    me being a NOOB, I haven't touched the retraction settings. What do you suggest as a good starting point.
     
    #3 paultnl, Aug 28, 2015
(You must log in or sign up to post here.)

Share This Page