Suggestions for a "Tool Kit" and "Techniques" to build a BigBox

Discussion in 'Build Help' started by Old_Tafr, Mar 8, 2016.

  1. Old_Tafr

    Old_Tafr Well-Known Member

    Joined:
    Mar 7, 2016
    Messages:
    558
    Likes Received:
    75
    To date I have found the service, the quality of the parts, instructions etc. to be good bordering on very good so this is not a complaint !

    But with the difficulty in fitting the springs in the Dual Extruder (echoed by a few others) as with anything there is always a different way to approach a problem.

    What I suggest (it may be part of an existing section ?) is a thread or maybe two on......

    Tools / Additional Tools (like screwdriver type Allen keys

    Techniques (e.g. for fitting recessed nuts and strong springs)

    Preferably without going too far off topic
     
  2. Stefan

    Stefan Well-Known Member

    Joined:
    Feb 17, 2016
    Messages:
    323
    Likes Received:
    43
    Hi I think this stick which is now in calibration sun form is meant for.
     

Share This Page