SW x1 hemera z axis problem

Discussion in 'Troubleshooting' started by Dimitry Poznyakov, Feb 12, 2020.

  1. Dimitry Poznyakov

    Dimitry Poznyakov New Member

    Joined:
    Feb 12, 2020
    Messages:
    1
    Likes Received:
    0
    Installed a hemera kit on SW and got a problem.

    During print, printer does not respond to z axis commands while printing first bottom layers. Checked and re-checked everything. VREF, firmware, pid, etc.

    The problem stays on cura, s3d slicer, even printing from usb.

    gcode for printing contains a proper commands for z axis, but printer does not respond

    Probably some kind of firmware problem? or end stop location?
     
  2. johny

    johny Member

    Joined:
    Jan 20, 2020
    Messages:
    17
    Likes Received:
    4
    Does the Z-axis move as expected when not printing, i.e. when controlled via the TFT screen or over USB?
     

Share This Page