Taulman spools

Discussion in 'BigBox General Chat' started by Henry feldman, Jan 6, 2016.

  1. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    391
    Will the holder on the back accommodate the small Taulman3D spools. I will mostly be printing Nylons and other structural plastics, but these spools are much smaller.
     
  2. Colin

    Colin Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    86
    Likes Received:
    20
    I have a roll of t-glase at home, if nobody has answered by tonight I will put it on and check for you.
     
  3. Mike Kelly

    Mike Kelly Volunteer

    Joined:
    Mar 7, 2014
    Messages:
    450
    Likes Received:
    93
    Yes!. It's a very modular design, supports almost any rigid spool out there.
     
    JohnEsc likes this.
  4. Colin

    Colin Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    86
    Likes Received:
    20
    Fits just fine, the slider that usually locks into the middle of the roll goes on top and it spins without issue.

    unnamed (3).jpg
     
    Pierce and JohnEsc like this.
  5. Henry feldman

    Henry feldman Well-Known Member

    Joined:
    Sep 5, 2015
    Messages:
    969
    Likes Received:
    391
    perfect. Thanks.
     

Share This Page