temp calibration of PT100

Discussion in 'General' started by Frostbyte, Aug 30, 2016.

  1. Frostbyte

    Frostbyte New Member

    Joined:
    Aug 30, 2016
    Messages:
    1
    Likes Received:
    0
    I plan on installing the PT100 Amplifier board on the X carriage of my RigidBot. This leaves quite a distance of wire between the Thermocouple and Amp Board. Does the amplifier compensate for the decreased resistance between it and the thermocouple? If not, how much wire can I remove before calibration is affected, or, how do I recalibrate the amp board for the resistance change?
     

Share This Page