Temp Error e3d Chimera on UM 2+

Discussion in 'Multi-Extrusion' started by saminflux, Jun 26, 2018.

  1. saminflux

    saminflux New Member

    Joined:
    Jun 26, 2018
    Messages:
    1
    Likes Received:
    0
    hallo,

    I upgraded my ultimaker 2+ to a dual extrusion Chimera, bought direct from E3D.
    Upon firing up my printer I get " Error Stopped , Temp Sensor".
    I uploaded the firmware as indicated on the upgrade page for the Chimera.
    I also compiled a custom Marlin firmware, again using the given values from
    https://wiki.e3d-online.com/E3D-v6_on_Ultimaker_2#Accessing_the_Control_Board.
    to no avail.
    I tested with an extra PT sensor from a spare Heatbed, that worked fine.
    I tested with a spare PT100 sensor, also bought direct from E3D. That returned a Temp ERROR.
    I am at a loss.
    Can someone help? point in a direction?
    thanks
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    614
    Likes Received:
    100
    Does your spare PT100 sensor have red leads?

    What is its resistance at room temperature?
     

Share This Page